TagLine aquí

Matek Tail light WS2812B & Loud Buzzer, Dual modes

U$S -7.00







It comes as H Type tail light with 8xWS2812B LEDs & Loud Buzzer. It provides dual control modes, can be controlled by Flight Controller firmware (Cleanflight, Betaflight,etc.) or Transmiter.

Dual modes: FC control & TX control
TX mode: LED 7 colors (White, Red, Green, Blue, Yellow, Magenta, Cyan) LED 5 status (Constant light, Slow blink, Fast blink, Voilent blink)
Buzzer: Lost Plane Finder
FC mode: support Naze32, SPRacingF3, etc. with CleanFlight or Betaflight firmware
Input voltage range: 4.5~5.2V DC
Power of TX mode (5V IN ): 1W/0.2A~2W/0.4A
Size & mounting: Pls check the Layout
Weight: 5g

1. Connect Tail Light to 5V power source, such as BEC 5V. Beep once if it is in TX mode.
2. Press the button, scroll through the LED status(Constant light, Slow flash, Fast flash, Voilent flash)
3. Hold the button 2s to enter the setting of LED colors & mode(Be Be Be), then press the button to set it within LED colors of TX mode (White, Red, Green, Blue, Yellow, Magenta, Cyan) & FC mode (all LED OFF)
4. The LED color(TX mode) or FC mode will be saved if no action within 10 seconds(Be----).
5. Tips:
Default is TX mode with solid & white color LED
If DIN is connected to FC, Pls disconnect it & re-energize the board when changing FC mode to TX mode.
In FC mode, the LED status can’t be changed by pressing the button. But you can hold the button 2s to enter the setting menu.











Agotado

Derechos © 2018 FPV Shop. Tienda Software:Zen Cart | Red Passion theme by CssTemplateHeaven